Fuyang Sensi Trading Co.,ltd.
Quality,Careful & Health,
One-stop supplier of face masks raw material!
Contact Supplier
Lates Posts
  • Understanding of FFP2 Meltblown Non-woven Fabric and Physical Properties of PP Spunbond Non-woven Cloth
    06-05.23
    Physical properties of PP spunbond non-woven clothPP spunbond non-woven cloth has been popular among consumers in recent years, largely due to its composition. What are the physical properties of PP n...
  • An In-Depth Explanation About N95 and Medical Protective Masks
    05-29.23
    A common category of masksAccording to the function masks can be divided into:Cold-proof masksIs our daily use of cotton masks, mainly to play the role of warmth, no anti-drug dust-proof role, mainly ...
  • Introduction of Disposable Masks, Surgical Masks, and KN95 Masks
    05-22.23
    Disposable maskDisposable masks are made of two layers of 28 grams of non-woven fabric; breathable and suitable for electronics factories/food industry and other daily use; no obstruction to virus eff...
Free Quote

The Production Process of Melt Blown Cloth Manufacturers

As a melt-blown cloth manufacturer, SENCI would like to introduce to you based on the actual operation information of the melt-blown cloth factory. The spinning technology mainly includes the melt extrusion rate, hot air speed and melt temperature of the meltblown fabric.


1. Melt extrusion of melt-blown cloth


The extrusion volume of the polymer melt produced by a meltblown fabric factory affects the linear density and yield of the fiber. The higher the grams of polymer melt extruded from the fuse hole per minute, the thicker the fiber. Therefore, on the premise of ensuring fiber fineness, the number of spinneret holes needs to be increased to increase the production value of meltblown nonwovens.


2. The draft speed of the melt-blown cloth


The secondary hot melt flow rate of the process parameters directly affects the fineness of the fiber during the injection process. Polymer melts and a certain amount of melt viscosity for extrusion, higher air-drawing speeds, wire drawing effects, microfluidics for melt spinning polymers?


In industrial production, with the rapid development of information technology, ventilation hot air can be used to compensate for the continuous change of fiber hole diameter caused by the addition of polymer extrusion time, that is, the flow of secondary hot air is necessary with the polymer extrusion phase. match.


3. Melting temperature of melt-blown cloth


The meltblown temperature of the melt blown cloth is the working temperature, which can be used to adjust the melt viscosity of the polymer melt nozzle. The melting temperature is usually higher than the melting point of the PP resin in the viscous active state. When other process conditions are kept constant, the melt viscosity of the polymer decreases and the melt mobility is better.


Thus, microfibers can be easily obtained by melt spraying using high MF polymer flake materials. However, if the melt viscosity of the melt blown non woven fabric factory is too low, it will cause excessive expansion of the melt activity, and the short microfiber form will fly into the air and cannot be collected.


Fuyang Sensi Trading Co., Ltd. is a professional one-stop supplier of medical products such as masks. Mainly produce nose straps, ear loops, pp spunbond non-woven fabrics, melt-blown non-woven fabrics, BFE 99.95.98 fabrics, FFP1 FFP2 FFP3 melt-blown non-woven fabrics, ES non-woven fabrics, activated carbon fabrics.


We provide them with high quality pp spunbond, meltblown fabric, nose wire and ear loops at lower prices. We also help them produce better products, which are warmly welcomed by buyers all over the world. Welcome to consult.

The Production Process of Melt Blown Cloth Manufacturers
http://www.fysensi.com